Toll Free: 800-203-0295
Michigan: 269-222-0104
Illinois: 815-272-2695
Toll Free: 800-203-0295
Indiana: 765-299-8943 & 574-875-1740   Michigan: 269-222-0104   Illinois: 815-272-2695

Commercial Roof Coatings & Restoration

If your roof is worn but still dry underneath, you may not need a tear-off. A restoration coating goes over the existing roof, seals it, reflects heat, and can add years of service life for a fraction of what replacement costs.

A-1 has applied roof coatings on commercial and industrial buildings across Indiana, Michigan and Illinois. Before you spend anything, we’ll tell you if your roof is a good candidate.

Sheraton Roofing Installation
PVC White Membrane Roofing

coating restortion

Is your roof a good candidate?

Coatings work best when:

  • The existing membrane or metal is intact across most of the roof
  • The insulation underneath is dry, or wet areas are limited and can be cut out and replaced
  • The roof drains reasonably well
  • The roof is aging but hasn’t reached widespread failure

*Note: Coatings are a poor fit for roofs with large areas of wet insulation, heavy ponding, or a deck that’s deteriorating. Putting a coating over those problems just seals them in.

commercial roof coatings

What a coating does for the building

Seals seams, fasteners and small cracks across the whole roof surface

Reflects sunlight, which can lower roof surface temperature and cooling load

Avoids the disruption, debris and landfill cost of a full tear-off

Can be recoated later to extend the roof life again

commercial roof restoration

How restoration works

We start with an inspection and moisture survey to confirm the roof is sound. Then we clean the surface, repair seams, flashings and damaged areas, and replace any wet insulation. Primer goes down where the system calls for it, followed by the coating in one or more coats at the specified thickness.

Surface prep is the part that decides whether a coating lasts. Skipping it is the most common reason coatings peel.

Please don’t send employees onto a wet, icy or wind-damaged roof. That’s how people get hurt.

Coating types

Silicone, acrylic and urethane coatings each have strengths. Silicone handles ponding water better than most. Acrylic is common on metal roofs and in areas without much standing water. We’ll recommend the system that fits your roof’s condition and drainage.

Why building owners call A-1

We have been doing this for more than four decades. Many of our crew members have been with us over fifteen years, so the person on your roof has seen your type of building and your type of failure many times before.

Frequently asked questions

Is a roof coating cheaper than replacement?

Usually by a significant margin, because there’s no tear-off, less labor and no disposal cost. The savings only hold up if the roof underneath is sound.

Can you coat a roof with a leak?

Leaks and damaged areas are repaired before the coating goes on. A coating is part of a restoration, and the repairs come first.

Will my insurance cover storm damage to my roof?

That depends on your policy and the cause of the damage. We provide photo documentation you can give your carrier. Your agent or adjuster can tell you what’s covered.

Can coatings go over metal roofs?

Yes. Metal roofs are one of the most common coating applications. Rust is treated and fasteners are sealed as part of the prep.

Wondering if your roof can be restored instead of replaced?

Call now for an inspection.

Tell us about your roof.

Send us your building details and we’ll follow up to schedule an inspection. If water is coming in now, call 574-875-1740.